Country Home Products DR 4 -TON Operations Instructions download pdf (Page 19)

CALL TOLL-FREE 1-800-DR-OWNER 15

Attaching the Yoke

Tool Needed:

• (2) 9/16" Wrench

1. Position the Yoke in front of the DR POWER GRADER and inside of the Side Rails (Figure 10).

2. Align the Holes in the end of the Yoke with the Holes in the Side Rails and attach each side of the

Yoke to the Side Rails using a 3/8"-16 x 1-1/2" Bolt, 3/8" Flat Washer and 3/8" Lock Nut (Figure 10).

Do not tighten at this time

NOTE: To allow the Yoke to pivot up and down, DO NOT fully tighten the Lock Nut against the hardware. Back

the Lock Nut off 1/4 to 1/2 turn after contact with the hardware.

3/8"

Bolt, Washer,

and Lock Nut

Yoke

Side Rail

Figure 10

Front

Figure 9a

Battery Strap

Wire Tie

Figure 9b

Wire Tie

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 39 40

No comments

Country Home Products DR 4 -TON Operations Instructions Page 19