Country Home Products DR 4 -TON Operations Instructions download pdf (Page 13)

Installing and Removing the Edger

BEFORE PERFORMING ANY MAINTENANCE PROCEDURE, STOP THE ENGINE AND DISCONNECT

THE SPARK PLUG WIRE.

CALL TOLL FREE 1-800-DR-OWNER 9

Figure 7

J Slot

THE TRANSMISSION IS HOT DURING AND AFTER USE.

TYPICAL SURFACE TEMPERATURES RANGE BETWEEN 110

AND 180° FAHRENHEIT. DO NOT TOUCH THE

TRANSMISSION UNTIL A COOL DOWN PERIOD OF 15-30

MINUTES HAS PASSED. COOL DOWN TIME CAN VARY

DEPENDING ON THE OUTDOOR TEMPERATURE AND

OPERATING CONDITIONS.

Using the edger accessory on your DR

TRIMMER/MOWER™, you can cut clean borders around

trees, flowerbeds, walkways, shrubs, and gardens.

Note: The following steps are based on the Trimmer’s left

and right as if you were standing at an operating position

behind the Trimmer’s handles.

1. Install the Edger on the Trimmer’s left by sliding the

Edger’s axle over the shaft of the transmission,

rotating the Edger to align the J-slot in the axle (Figure

7) with the drive pin (Figure 8) and pushing the Edger

axle toward the transmission (Figure 9).

Drive Pin

Figure 8

Note: There is a spring that you will compress as you push

the Edger onto the shaft until the drive pins bottom on the

slot in the Edger axle. This will require a fair amount of force

to overcome the spring tension.

Figure 9

When the Edger axle is inserted completely, rotate the

Edger clockwise until it reaches the end of the J-slot

(

Figure 9

Note: When the Edger is released, it should lock into the end

of the J-slot and should not turn in either direction. Check to

see that the Edger is locked into place by trying to turn it both

clockwise and counterclockwise.

3. To remove the Edger, simply reverse the procedure by

pushing the Edger in, twist counterclockwise and

release.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 21 22

No comments

Country Home Products DR 4 -TON Operations Instructions Page 13