Country Home Products 10 HP Operations Instructions download pdf (Page 44)

40 DR

10 HP CHIPPER

BEFORE PERFORMING ANY MAINTENANCE PROCEDURE OR INSPECTION, STOP THE ENGINE, WAIT FIVE

(5) MINUTES TO ALLOW ALL MOVING PARTS TO COME TO A COMPLETE STOP AND COOL. DISCONNECT

THE SPARK PLUG WIRE, KEEPING IT AWAY FROM THE SPARK PLUG.

SYMPTOM POSSIBLE CAUSE

The engine lacks

power or is not

running smoothly.

(Please refer to the

Engine Owner’s

Manual for engine-

specific

procedures.)

⇒ Check the Throttle travel. Is the Throttle Lever in the Run position?

⇒ Is the Choke Lever pushed all the way to the left (RUN)?

⇒ Is the air filter clean? If it’s dirty, change it following the procedure in the Engine

Owner’s Manual.

⇒ Is the spark plug clean? If it’s fouled or cracked, change it. If it’s oily, leave it out,

hold a rag over the spark plug hole and pull the recoil cord several times to blow out

any oil in the cylinder, then wipe off the spark plug and reinsert it.

⇒ Are you using fresh, clean unleaded gas? If it is old, change it. Use a fuel stabilizer

if you keep gas longer than one month.

⇒ Does your engine have the right amount of clean oil? If it is dirty, change it

following the procedure on page 27.

⇒ If your engine still lacks power, call 1(800) DR-OWNER (376-9637) for assistance.

Engine smokes.

⇒ Check the oil level and adjust as needed.

⇒ You may be operating the machine on too great an incline. The machine should be

level.

⇒ Check the air filter and clean or replace if needed.

⇒ You may be using the wrong oil - too light for the temperature. Refer to your Engine

Owner’s Manual for detailed information.

⇒ Clean the engine cooling fins and the carburetor housing if they are dirty.

⇒ If the engine still smokes, call 1(800) DR-OWNER (376-9637) for assistance.

Flywheel will not

turn.

⇒ The Flywheel may be jammed. Immediately stop the engine. Remove any built-up

debris from the Chipper Hopper Inlet and Discharge Chute.

⇒ Check the Drive Pulley alignment and adjust if necessary.

⇒ Check the Drive Belt tension. See page 28.

⇒ Replace the Drive Belt or reinstall if the belt has come off the pulleys.

⇒ Turn the flywheel with a wooden stick to be sure it turns freely. If the Flywheel still

will not turn, call 1(800) DR-OWNER (376-9637) for assistance.

Drive Belt burns.

⇒ The Chipper is being overloaded; process material at a slower rate.

⇒

The Flywheel is jammed. See the Symptom above.

⇒ If the Drive Belt still burns, call 1(800) DR-OWNER (376-9637) for assistance.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 50 51 52

Comments to this Manuals

No comments

Country Home Products 10 HP Operations Instructions Page 44

Comments to this Manuals

Related products and manuals for Garden shredders Country Home Products 10 HP